Industrial Process Controls :: Flow Instruments

per page

      Field Indicators Flowmetrics
        
        Field Indicators are secondary display devices.  They also amplify, filter, condition, scale, and convert low level "raw" signals produced by many transducers and convert it into the desired industry standard high level signal prior to transmitting it across potentially environments.

Flow Computers & Batch Controllers

Flow Batch Controllers are special purpose instruments which are intended to be used in conjunction with a flow sensor and control valve to dispense a desired amount of fluid into a container, tank, or vehicle. In some cases the temperature may also by used to estimate the fluid density form stored fluid properties. Our batch controllers are capable of Batch Overrun Compensation, Two-Stage Batching, Slow Fill, Count Mode, as well as providing for a variety of other functions such as printing and remote start/stop.

      FMP Series Insertion Flowmeter
        
        FMP Series prime application is large diameter pipes or ducts where traditional flow meter equipment is bulky, expensive, or difficult to maintain. FMP Series are well suited in applications exhibiting high-pressure drop characteristics and/or limited flow ranges where "in-line" flow meters would not be suitable.  Ranges:  Liquid 0.3 FPS, Gas 1.0 FPS.

FMT Series Flowmeters

FMT Flowmeters are capable of measuring extremely low flow rates (0.002GPM in liquids and 0.01 ACFM in gases). The FMT flowmeter is a unique volumetric device which uses a dual-orifice design to direct a stream of fluid tangent to low mass/balanced rotor and a precision bearing to provide maximum sensitivity. This geometry also eliminates the need for flow straighteners and allows for greater repeatability.

      MAG/RF Pickups
        
        These Pickups are hermetically sealed for resistance to moisture and other atmospheric contamination and can withstand repeated thermocycling in temperatures ranging from -450 degrees F to 450 degrees F.

Ratemeters/Totalizers Flowmetrics

Rate/Totalizers are available to work with most flowmeter types and most common electrical signals produced by flowmeters. In some cases and amplifier or signal conditioner may be necessary. Non-Linearity corrections are available in some units.

      Series 2000 Variable Area Flowmeters
        
        Series 2000 Variable Area Flowmeter is a rugged industrial flowmeter available in a wide range of liquid and gas flow rates.  Series 2000 family includes flowmeters with a scale lengths of 150mm and 250mm.

Series 2600 Variable Area Flowmeters

Series 2600 (single stage) 600mm flowmetering panels offer the highest precision available in our product line of variable area flowmeters. Available capacities of 2.8cc/min up to 180 GPM for liquid or 100cc/min to 750 SCFM for gas. Suited for temperatures up to 250 degrees F/ 121 degrees C, can be mounted in-line or as a panel installation. Connections are available as NPT or MS and Vertical/Horizontal Flange.

      Series 4600 Variable Area Flowmeters (multi-stage)
        
        Series 4600 (Multi-Stage) 600mm flowmetering panels offer the highest precision available in our product line of variable area flowmeters.  This line has available capacities of 2.8cc/min up to 180 GPM for liquid or 100 cc/min to 750 SCFM for gas.  Suited for temperatures of to 250 degrees F/ 121 degrees C, it can be mounted in-line or as a panel installation.  Connections are available as NPT or MS and Vertical/Horizontal Flange.